![]() Low-speed may run automatically at times, during which it cannot be deactivated from the panel, but highspeed may be operated.ģ Jets 2 / Jets 3 / Blower (if equipped) Press the corresponding button once to turn the device on or off. High-speed will turn off after 15 minutes. The low-speed will turn off after 4 hours. Jets 1 Press Jets 1 to turn pump 1 on or off, and to shift between low and high speeds (if equipped). After three seconds, the display will stop flashing and begin to display the current spa temperature. ![]() To change the set temp, press a temp button again before the display stops flashing. To display the set temperature, press Warm os Cool once. The water temeprature displayed is current only when the pump has been running for at least 2 minutes. Temp Control (80 F F / 26.0 C C) The measured water temperature is constantly displayed. In multi button sequences, if the buttons are pressed too quickly int he sequence, they may not register. The pump responsible for heating and filtration (pump 1 low-speed on non-circ system, or the circ pump on circ system) will be referred to simply as the pump. ![]() After Priming Mode, the spa will run in Standard Mode (see Mod/Prog section). During Priming Mode, press Jets button(s) repeatedly and be sure all pumps are free of air. 2 Initial Start-up Your spa will enter Priming Mode (Pr) when it is energized.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |